Sacramento Emergency Plumber Service What are your personal thoughts on plumbing? Do you view everything you can on the subject and try to improve upon your own system at home? There are numerous resources available, such as magazines, videos, books, and shows. So where do you begin with your own system? Try going through these tips to find your starting point.
Before starting any plumbing project be sure to turn off the main water supply. Water damage can be one of the most expensive things to repair. To minimize damage turn the main water supply off as well as any shut off valves near where you are working. This will save a great deal of hardship later on.
Do not put cooking oils, fat, or grease, down your drain. These fats cause clogs by solidifying in pipes. To properly dispose of fats, put them in a bowl with a lid that you can dispose of. Once it gets hard, throw it in the trash or compost bin.
If you have issues with the plumbing making a hammering sound when you turn it off, check your water pressure. Any time your water pressure is above 80 PSI, you will hear extra water noise. This can be easily solved by the installation of a pressure-reducing valve, which can be done by most homeowners.
Unclog drains with ease. Try using a plunger and drain cleaner, as your clog may simply be a build-up of hair and debris. If this doesn't work you may have to clear the drain with a snake. Feed the snake into the drain line as far as it will go. Turn the crank gently, which will help to loosen the clog. Remove the snake, and run water down the drain to see if the clog has been removed. You may have to use the snake a couple of times, before the clog is cleared so don't give up!
Check your gas water heater periodically to make sure the pilot flame is lit. The correct color for this flame should be blue. The tip of the flame should be yellow. If you find that you are only seeing a yellow flame, you may need to call a professional for safety reasons.
Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.
Don't start any do-it-yourself plumbing project without having a plan in place. You need to know beforehand exactly what you are getting yourself into. Know what kind of space you are working with and what lines are which. Getting a clear picture early on will make your plumbing project go a lot smoother!
In conclusion, not all advice should be taken seriously. Be sure to be careful who you take advice from especially when it is something that could lead to much frustration in the future. This article hopefully provided all of the details that you need to know about plumbing.
No comments:
Post a Comment